Products
Advantages
Houses equipped with energy saving systems, built by integrating new technologies, allow you to obtain a high energy class, consequently increasing the value of the property. Compact and quick to install solutions to reduce space and installation times, modular and scalable to facilitate design aspects. The low costs, both purchase and installation, allow for a rapid amortization of the investment.
The saving of drinking water, the reduction of consumption and the high efficiency allow an optimization of the energy balance of the system, also with a view to sustainable construction.
Applications
Energy saving and sustainable management of resources
With every shower, 100 liters of water at 36° C are discharged into the sewer, with an unsustainable waste of energy and resources. The recovery of residual heat at the exhaust can halve the caloric consumption necessary for heating domestic water while the recovery and subsequent reuse of 100 liters of water contributes to responsible use of resources as well as significantly reducing consumption.
Grey water recovery
It is the gray water recovery system for irrigation or domestic use, pre-assembled and ready to be connected in minimal times during installation on site. Thanks to the use of highly efficient membranes, the filtration level is very high and allows bacteria and viruses to be removed. Furthermore, the new generation filters maintain high performance over time, extending maintenance intervals.
In fact, only one chemical wash of the membrane can be envisaged every 12/18 months and the automatic backwash cycle to keep the membranes clean sends the residues directly to the sewer.
The system, which can be sized based on the number of users, is completely automatic and can be controlled remotely.
Purification phases
- Primary filter+oxidation+ultrafiltration
- Storage
- Multi-stage filter + activated carbon
- UV disinfection
Ecoshower
Ecoshower is the innovative solution that recovers up to 40% of heat from gray water to release it, flowing against the current in a coil, integrating the feed water of both the boiler and the mixer (A) or of the mixer alone (B). The water that feeds the kettle, the instantaneous water heater or the mixer from the "cold" side typically reaches 10° C and is heated up to 50° C, generating a consumption of around 40Kcal/l. With the integration of ecoshower within the system, the incoming water is preheated to around 24° C, reducing energy requirements by 35%.
